The STL files for.. The Hand!

Files allowing you to print the model with a 3d printer for both personal and commercial use. At a little under 180mm it fits on both an A1 and A1 mini bed too!

The hand is a unique and playful photo magnet frame with lots of character – great for home, but especially great on a market stall or shop front as an attention grabber!

Available for 2 x 2 and 2.5 x 2.5 inch magnets (choose below)

Will magnets from x machine fit?

If your magnet press produces square magnets, regardless of variance between machines, you should be covered.

Included are multiple files for common press sizes,  test prints to check your fit, and a handy print and scaling guide should you need to make any subtle adjustments based on press technique or materials used. The design also results in a gravity fit due to the angle at which the magnet lays on the top section, so there’s no worries about any magnets falling out should you press a magnet slightly small/loose.

The design should cover pretty much any 2″ or 2.5″ press out there, but if you have any sizing issues just get in touch and I can make adjustments for you.

This is a downloadable purchase containing STL files for 3d printing only.

Included:

• STL files (the hand model)
• A full guide to 3d printing.

Approximate / average measurements:

Height: 174mm
Width: 120mm
Depth: 97mm

NOTES: Requires a flat surface to stand.

License details

Purchase of the STL files permits you to: Print the model for personal or commercial use, i.e gifting or selling the finished, fully printed model.

You are NOT permitted to: Share, sell, remix, or edit the STL files, either for personal or commercial use.