The STL files for our unique double photo magnet trinket tray, allowing you to print the model with a 3d printer for both personal and commercial use.

This trinket tray features an angled design with two photo magnets in view above a spacious tray, useful for holding jewelry, coins, keys and other trinkets.

Available for 2 x 2 and 2.5 x 2.5 inch magnets (choose below)

Will magnets from x machine fit?

If your magnet press produces square magnets, regardless of variance between machines, you should be covered.

Included are multiple files for common press sizes,  test prints to check your fit, and a handy print and scaling guide should you need to make any subtle adjustments based on press technique or materials used. The design also results in a gravity fit due to the angle at which the magnet lays on the top section, so there’s no worries about any magnets falling out should you press a magnet slightly small/loose.

The design should cover pretty much any 2″ or 2.5″ press out there, but if you have any sizing issues just get in touch and I can make adjustments for you.

This is a downloadable purchase containing STL files for 3d printing only.

Included:

• STL files (trinket tray)
• A full guide to 3d printing.

Approximate / average measurements:

2.2″ version
Length (across front): 16cm
Width (front to back depth): 16cm
Height: 7.5cm

2.5 ” version
Length (across front): 20.5cm
Width (front to back depth): 20cm
Height: 9.5cm

NOTE: Please check the sizes can fit on your printer bed. 

License details

Purchase of the STL files permits you to: Print the model for personal or commercial use, i.e gifting or selling the finished, fully printed model.

You are NOT permitted to: Share, sell, remix, or edit the STL files, either for personal or commercial use.