The STL files for our unique triple photo magnet trinket tray, allowing you to print the model with a 3d printer for both personal and commercial use.

This trinket tray features an angled design with three photo magnets in view above a spacious tray, useful for holding jewelry, coins, keys and other trinkets.

Available for 2 x 2 inch magnets. We also have one and two photo magnet trinket trays available for both 2 x 2″ and 2.5 x 2.5″ magnets. View our STL Files Collection to see our full range.

Will magnets from x machine fit?

If your magnet press produces square 2×2″ magnets, regardless of variance between machines, you should be covered.

Included are multiple files for common press sizes (Titan, MPRO etc),  test prints to check your fit, and a handy print and scaling guide should you need to make any subtle adjustments based on press technique or materials used. The design also results in a gravity fit due to the angle at which the magnet lays on the top section, so there’s no worries about any magnets falling out should you press a magnet slightly small/loose.

The design should cover pretty much any 2″ press out there, but if you have any sizing issues just get in touch and I can make adjustments for you.

This is a downloadable purchase containing STL files for 3d printing only.

Included:

• STL files (trinket tray)
• A full guide to 3d printing.

Approximate / average measurements:

Length (across front): 22.4cm
Width (front to back depth): 15.7cm
Height: 7.5cm

NOTE: Please check the sizes can fit on your printer bed. 

License details

Purchase of the STL files permits you to: Print the model for personal or commercial use, i.e gifting or selling the finished, fully printed model.

You are NOT permitted to: Share, sell, remix, or edit the STL files, either for personal or commercial use.