The STL files for our unique photo magnet trinket tray, allowing you to print the model with a 3d printer for both personal and commercial use.

This trinket tray features an angled design with a photo magnet in view above a spacious tray, useful for holding jewelry, coins, keys and other trinkets.

Available for 2 x 2 / 2 x 3 / 2.5 x 2 .5 / 2.5 x 3.5 inch magnets (choose below)

Will magnets from x machine fit?

Regardless of variance between machines, you should be covered.

Included are multiple files for common press sizes,  test prints to check your fit, and a handy print and scaling guide should you need to make any subtle adjustments based on press technique or materials used. The design also results in a gravity fit due to the angle at which the magnet lays on the top section, so there’s no worries about any magnets falling out should you press a magnet slightly small/loose.

The design should cover pretty much any press out there, but if you have any sizing issues just get in touch and I can make adjustments for you.

This is a downloadable purchase containing STL files for 3d printing only.

Included:

• STL files (trinket tray)
• A full guide to 3d printing.

Approximate / average measurements:

2×2″ version
Depth(front to back): 16cm / Width: 10cm / Height: 7.5cm

2.5×2.5″ version
Depth (front to back): 17.9cm / Width: 11.9cm / Height: 8.2cm

2×3″ version
Depth (front to back): 16.9cm / Width: 13.3cm / Height: 8cm

2.5×3.5″ version
Depth (front to back): 17.9cm / Width: 14.4cm / Height: 8.2cm

NOTE: Please check the sizes can fit on your printer bed. (These should all fit on A1 mini without issue)

License details

Purchase of the STL files permits you to: Print the model for personal or commercial use, i.e gifting or selling the finished, fully printed model.

You are NOT permitted to: Share, sell, remix, or edit the STL files, either for personal or commercial use.